Search results
Results from the Tech24 Deals Content Network
A binary-to-text encoding is encoding of data in plain text. More precisely, it is an encoding of binary data in a sequence of printable characters. These encodings are necessary for transmission of data when the communication channel does not allow binary data (such as email or NNTP) or is not 8-bit clean. PGP documentation ( RFC 4880) uses ...
A binary code represents text, computer processor instructions, or any other data using a two-symbol system. The two-symbol system used is often "0" and "1" from the binary number system. The binary code assigns a pattern of binary digits, also known as bits, to each character, instruction, etc. For example, a binary string of eight bits (which ...
This is a list of some binary codes that are (or have been) used to represent text as a sequence of binary digits "0" and "1". Fixed-width binary codes use a set number of bits to represent each character in the text, while in variable-width binary codes, the number of bits may vary from character to character.
A binary number is a number expressed in the base -2 numeral system or binary numeral system, a method for representing numbers that uses only two symbols for the natural numbers: typically "0" ( zero) and "1" ( one ). A binary number may also refer to a rational number that has a finite representation in the binary numeral system, that is, the ...
uuencoding. uuencoding is a form of binary-to-text encoding that originated in the Unix programs uuencode and uudecode written by Mary Ann Horton at the University of California, Berkeley in 1980, [1] for encoding binary data for transmission in email systems.
Base62. The base62 encoding scheme uses 62 characters. The characters consist of the capital letters A-Z, the lower case letters a-z and the numbers 0–9. It is a binary-to-text encoding scheme that represents binary data in an ASCII string format. [1] [2]
A translator using static binary translation aims to convert all of the code of an executable file into code that runs on the target architecture without having to run the code first, as is done in dynamic binary translation. This is very difficult to do correctly, since not all the code can be discovered by the translator.
The binary prefixes, as defined by IEC 80000-13, are incorporated into ISO 80000-1, including a note that "SI prefixes refer strictly to powers of 10, and should not be used for powers of 2." In ISO 80000-1, the application of the binary prefixes is not limited to computer technology. For example, 1 KiHz = 1024 Hz.