Search results
Results from the Tech24 Deals Content Network
Total harmonic distortion, or THD is a common measurement of the level of harmonic distortion present in power systems. THD can be related to either current harmonics or voltage harmonics, and it is defined as the ratio of the RMS value of all harmonics to the RMS value of the fundamental component times 100%; the DC component is neglected.
Capacitors and inductors as used in electric circuits are not ideal components with only capacitance or inductance.However, they can be treated, to a very good degree of approximation, as being ideal capacitors and inductors in series with a resistance; this resistance is defined as the equivalent series resistance (ESR).
Four stages of skin effect in a coax showing the effect on inductance. Diagrams show a cross-section of the coaxial cable. Color code: black = overall insulating sheath, tan = conductor, white = dielectric, green = current into the diagram, blue = current coming out of the diagram, dashed black lines with arrowheads = magnetic flux (B). The ...
Power semiconductor devices have a maximum power dissipation rating usually quoted at a case temperature of 25 °C (77 °F). The datasheet for the device also includes a derating curve which indicates how much a device will dissipate without getting damaged at any given case temperature, and this must be taken into account while designing a system.
The MOSFET is also capable of handling higher power than the JFET. [33] The MOSFET was the first truly compact transistor that could be miniaturised and mass-produced for a wide range of uses. [6] The MOSFET thus became the most common type of transistor in computers, electronics, [34] and communications technology (such as smartphones). [35]
Transistor–transistor logic (TTL) is a logic family built from bipolar junction transistors.Its name signifies that transistors perform both the logic function (the first "transistor") and the amplifying function (the second "transistor"), as opposed to earlier resistor–transistor logic (RTL) and diode–transistor logic (DTL).
ASME Y14.44-2008 [1] and IEEE 315-1975 [2] define how to reference and annotate components of electronic devices. It breaks down a system into units, and then any number of sub-assemblies. The unit is the highest level of demarcation in a system and is always a numeral.
Susceptibility of electronic equipment to these other electric power disturbances is defined by other aspects of the system design, either inside the equipment itself or externally by means such as a UPS, a voltage regulator or a surge protector with built-in overvoltage protection (which typically consists of a voltage-sensing circuit and a ...