Search results
Results from the Tech24 Deals Content Network
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
12 ft. Metric ( SI) units. 25.4 mm. A fire hydrant marked as 3-inch. The inch (symbol: in or ″) is a unit of length in the British Imperial and the United States customary systems of measurement. It is equal to 1 36 yard or 1 12 of a foot. Derived from the Roman uncia ("twelfth"), the word inch is also sometimes used to ...
In digital photography, the image sensor format is the shape and size of the image sensor . The image sensor format of a digital camera determines the angle of view of a particular lens when used with a particular sensor. Because the image sensors in many digital cameras are smaller than the 24 mm × 36 mm image area of full-frame 35 mm cameras ...
1:120: 0.1 in: 2.54 mm: Model railways (TT) Derived from the scale of 1 inch equals 10 feet.TT model railroad scale. Used in AD&D Battlesystem Skirmishes rules. Works with 15 mm miniatures where a 6 foot man would equal 15.24 mm 1:110: 2.771 mm Used for some model ships, aircraft and diecast cars. 1:108: 2.822 mm
[1] The Charrière is measured by the ''outer'' diameter, and is defined as 1 Fr = 1/3 mm, and thus 1 mm = 3 Fr; therefore the diameter of a round catheter in millimetres can be determined by dividing the French size by 3. [2] The French units roughly correspond to the outer circumference of the catheter (see table below).
Schematic of a machine tap. Below is a comprehensive drill and tap size chart for all drills and taps, imperial and metric, up to 36.5 millimetres (1.44 in) in diameter.. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.
The optical format is approximately the diagonal length of the sensor multiplied by 3/2. The result is expressed in inches and is usually (but not always) rounded to a convenient fraction. For instance, a 6.4x4.8 mm sensor has a diagonal of 8.0 mm and therefore an optical format of 8.0*3/2 = 12 mm, which is expressed as inch in imperial units.
From 1.0 through 2.95 mm, sizes are defined as follows, where N is an integer from 10 through 29: N · 0.1 mm; N · 0.1 + 0.05 mm; From 3.0 through 13.9 mm, sizes are defined as follows, where N is an integer from 30 through 139: N · 0.1 mm; From 14.0 through 25.0 mm, sizes are defined as follows, where M is an integer from 14 through 25: M ...