Search results
Results from the Tech24 Deals Content Network
Binary-coded decimal (BCD) is a binary encoded representation of integer values that uses a 4-bit nibble to encode decimal digits. Four binary bits can encode up to 16 distinct values; but, in BCD-encoded numbers, only ten values in each nibble are legal, and encode the decimal digits zero, through nine. The remaining six values are illegal and ...
The Hamming(7,4) code may be written as a cyclic code over GF(2) with generator + +. In fact, any binary Hamming code of the form Ham(r, 2) is equivalent to a cyclic code, [3] and any Hamming code of the form Ham(r,q) with r and q-1 relatively prime is also equivalent to a cyclic code. [4]
Formally, a parity check matrix H of a linear code C is a generator matrix of the dual code, C ⊥. This means that a codeword c is in C if and only if the matrix-vector product Hc ⊤ = 0 (some authors [1] would write this in an equivalent form, cH ⊤ = 0.) The rows of a parity check matrix are the coefficients of the parity check equations. [2]
Type II codes are binary self-dual codes which are doubly even. Type III codes are ternary self-dual codes. Every codeword in a Type III code has Hamming weight divisible by 3. Type IV codes are self-dual codes over F 4. These are again even. Codes of types I, II, III, or IV exist only if the length n is a multiple of 2, 8, 4, or 2 respectively.
The exception to this result is a bit pattern the same as that of the generator polynomial. All uneven bit errors are detected by generator polynomials with even number of terms. 2-bit errors in a (multiple) distance of the longest bitfilter of even parity to a generator polynomial are not detected; all others are detected.
Gold code. A Gold code, also known as Gold sequence, is a type of binary sequence, used in telecommunications (CDMA) [1] and satellite navigation (GPS). [2] Gold codes are named after Robert Gold. [3][4] Gold codes have bounded small cross-correlations within a set, which is useful when multiple devices are broadcasting in the same frequency range.
The cyclic binary code is also known as the cyclic progression code, the reflected binary code, and the Gray code. This code was originated by G. R. Stibitz, of Bell Telephone Laboratories, and was first proposed for pulse-code modulation systems by Frank Gray, also of BTL. Thus the name Gray code.
The default OperandSize and AddressSize to use for each instruction is given by the D bit of the segment descriptor of the current code segment - D=0 makes both 16-bit, D=1 makes both 32-bit. Additionally, they can be overridden on a per-instruction basis with two new instruction prefixes that were introduced in the 80386: