Search results
Results from the Tech24 Deals Content Network
1. Remove the label spool from inside of the printer and separate the spool disk from the spindle. 2. Hold the spool spindle (A) in your left hand and place the label roll on the spindle so that the labels feed from underneath and the left edge of the label roll is firmly against the side of the spool. 3.
Printer and label selection. Select an installed printer at the bottom of the screen, on the right of the side bar. Select the label in the left side bar by going to the Labels tab > Label Types. Select the label category from the dropdown list next to 'Show'. Find the label size you are using on the list below.
How to use DYMO Label Software v.8? DYMO Label Software v.8, Windows, MacOS, how to use, manual, user guide, editing labels, adding barcode, adding QR code, importing data, DYMO Label address book, 508 compliance, foreign characters, unicode, DHC
Printer and label selection. 1. Click on the 'New' button in the top left corner. 2. A new window opens where you can adjust the settings. 3. On the left, choose which installed printer you want to use. 4. On the right, choose which label or tape to use, use the name, size or product code of your label or tape.
The steps on how to maintain your label maker can be found HERE. 1. Turn off the LabelManager. 2. Open the cartridge door to access the tape compartment. 3. Remove the tape cassette. 4. Slowly begin closing the tape compartment door while keeping a close eye on the print head.
Insert the iron-on label cassette into the LetraTag. Input the desired text, print your label, and remove carbon from the front of the label. Set dry iron on medium high temperature (290°F to 370°F, or 130°C to 170°C). Remove any wrinkles from fabric by ironing the section where you want to place the label.
If the ribbon is not tight then tighten it by turning the black spool in the cassette clockwise until the ink ribbon is tight against the label tape. The ink ribbon in the tape cassette may also be broken or severed. Replace the tape cassette if that is the case. If the ink ribbon is intact, insert it back into the printer firmly or align it ...
Make sure it is connected directly without USB hubs or docks. 4. Plug the power cable back into the printer and turn the printer on. 5. If the labels are not detected again, close DYMO Connect and run it as administrator. 5. Insert a different roll of labels into the printer and feed them through.
1. Remove the Li-ion battery.2. Disconnect the power supply.3. Use a dry cotton swab to wipe the silver connectors of the battery.4. Press the power button 20 times to discharge the printer.5. Reinsert the battery into the device.6. Ensure the battery is fully charged. Reset the printer to factory settings. 1.
1. Make sure the power is on. If you just pressed the power button, wait 30 seconds for the printer to fully boot up. 2. Using a pointed object, not metal, press and hold the RESET button on the back of the printer for at least five seconds. 3. After five seconds, release the RESET button to initiate printer reset.