Search results
Results from the Tech24 Deals Content Network
A 2.26 kΩ, 1%-precision resistor with 5 color bands (), from top, 2-2-6-1-1; the last two brown bands indicate the multiplier (×10) and the tolerance (1%).. An electronic color code or electronic colour code (see spelling differences) is used to indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others.
The first letter of the color code is matched by order of increasing magnitude. The electronic color codes, in order, are: 0 = Black; 1 = Brown; 2 = Red; 3 = Orange; 4 = Yellow; 5 = Green; 6 = Blue; 7 = Violet; 8 = Gray; 9 = White; Easy to remember. A mnemonic which includes color name(s) generally reduces the chances of confusing black and brown.
IEC 60227 Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V. IEC 60228 Conductors of insulated cables. IEC 60229 Electric cables – Tests on extruded over-sheaths with a special protective function. IEC 60230 Impulse tests on cables and their accessories.
Ring color Significant figures Multiplier Tolerance Temperature coefficient Name Code RAL Percent [%] Letter [ppm/K] Letter; None – – – – ±20: M
Two decades of E12 values, which would give resistor values of 1 Ω to 82 Ω. The E series is a system of preferred numbers (also called preferred values) derived for use in electronic components. It consists of the E3, E6, E12, E24, E48, E96 and E192 series, [1] where the number after the 'E' designates the quantity of logarithmic value "steps ...
The RKM code, also referred to as "letter and numeral code for resistance and capacitance values and tolerances", "letter and digit code for resistance and capacitance values and tolerances", or informally as "R notation" is a notation to specify resistor and capacitor values defined in the international standard IEC 60062 (formerly IEC 62) since 1952.
A common type of axial-leaded resistor today is the metal-film resistor. Metal Electrode Leadless Face ( MELF) resistors often use the same technology. Metal film resistors are usually coated with nickel chromium (NiCr), but might be coated with any of the cermet materials listed above for thin film resistors.
A common application of the 25-pair color code is the cabling for the Registered Jack interface RJ21, which uses a female 50-pin miniature ribbon connector, as shown in the following table. The geometry of the pins of the receptacle (right hand image) corresponds to the pin numbers of the table.