Search results
Results from the Tech24 Deals Content Network
This did not work for characters not in the Windows Code Page (such as box-drawing characters). The new Alt+0### combination (which prefixes a zero to each Alt code), produces characters from the newer "Windows code pages." [a] For example, Alt+ 0 1 6 3 yields the character £ (symbol for the pound sterling) which is at 163 in CP1252. [2] [b]
Under Windows, the Alt key is pressed and held down while a decimal character code is entered on the numeric keypad; the Alt key is then released and the character appears. The numerical code corresponds to the character’s code point in the Windows 1252 code page, with a leading zero; for example, an en dash (–) is entered using Alt+0150 ...
1 Control-C has typically been used as a "break" or "interrupt" key. 2 Control-D has been used to signal "end of file" for text typed in at the terminal on Unix / Linux systems. Windows, DOS, and older minicomputers used Control-Z for this purpose. 3 Control-G is an artifact of the days when teletypes were in use.
To use the shortcut, turn on NumLock / Fn, and make sure the cursor is flashing where you want the symbol to go. Press and hold the alt key, and then press numbers. You don’t need to press the ...
This page lists codes for keyboard characters, the computer code values for common characters, such as the Unicode or HTML entity codes (see below: Table of HTML values "). There are also key chord combinations, such as keying an en dash ('–') by holding ALT+0150 on the numeric keypad of MS Windows computers.
A legacy of code page 437 is the number combinations used in Windows Alt codes. [6] [7] [8] A DOS user could enter a character by holding down the Alt key and entering the character code on the numpad [6] and many users memorized the numbers needed for CP437 (or for the similar CP850).
The Supplemental Mathematical Operators block (U+2A00–U+2AFF) contains various mathematical symbols, including N-ary operators, summations and integrals, intersections and unions, logical and relational operators, and subset/superset relations. Supplemental Mathematical Operators [1] Official Unicode Consortium code chart (PDF) 0.
In the narrowest sense, a control code is a character with the general category Cc, which comprises the C0 and C1 control codes, a concept defined in ISO/IEC 2022 and inherited by Unicode, with the most common set being defined in ISO/IEC 6429. Control codes are handled distinctly from ordinary Unicode characters, for example, by not being ...