Search results
Results from the Tech24 Deals Content Network
The physical address of computer memory banks may be mapped to different logical addresses for various purposes. In a system supporting virtual memory, there may actually not be any physical memory mapped to a logical address until an access is attempted. The access triggers special functions of the operating system which reprogram the MMU to ...
Diagram of relationship between the virtual and physical address spaces. In computing, a physical address (also real address, or binary address), is a memory address that is represented in the form of a binary number on the address bus circuitry in order to enable the data bus to access a particular storage cell of main memory, or a register of memory-mapped I/O device.
In early computers logical and physical addresses corresponded, but since the introduction of virtual memory most application programs do not have a knowledge of physical addresses. Rather, they address logical addresses, or virtual addresses, using the computer's memory management unit and operating system memory mapping; see below.
The maximum logical address space for a context is 1024 pages or 2 MB. The maximum physical address that can be mapped simultaneously is also 2 MB. The context register is important in a multitasking operating system because it allows the CPU to switch between processes without reloading all the translation state information.
The page table is a key component of virtual address translation that is necessary to access data in memory. The page table is set up by the computer's operating system, and may be read and written during the virtual address translation process by the memory management unit or by low-level system software or firmware.
Memory paging. In computer operating systems, memory paging (or swapping on some Unix-like systems) is a memory management scheme by which a computer stores and retrieves data from secondary storage [a] for use in main memory. [citation needed] In this scheme, the operating system retrieves data from secondary storage in same-size blocks called ...
In logical block addressing, only one number is used to address data, and each linear base address describes a single block. The LBA scheme replaces earlier schemes which exposed the physical details of the storage device to the software of the operating system. Chief among these was the cylinder-head-sector (CHS) scheme, where blocks were addressed by means
Address space. In computing, an address space defines a range of discrete addresses, each of which may correspond to a network host, peripheral device, disk sector, a memory cell or other logical or physical entity. For software programs to save and retrieve stored data, each datum must have an address where it can be located.