Search results
Results from the Tech24 Deals Content Network
The first letter of the color code is matched by order of increasing magnitude. The electronic color codes, in order, are: 0 = Black; 1 = Brown; 2 = Red; 3 = Orange; 4 = Yellow; 5 = Green; 6 = Blue; 7 = Violet; 8 = Gray; 9 = White; Easy to remember. A mnemonic which includes color name(s) generally reduces the chances of confusing black and brown.
A 2.26 kΩ, 1%-precision resistor with 5 color bands (), from top, 2-2-6-1-1; the last two brown bands indicate the multiplier (×10) and the tolerance (1%).. An electronic color code or electronic colour code (see spelling differences) is used to indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others.
In the machine tool industry it also known as G-code. In the PCB industry Standard Gerber, now revoked, was based on it. RS-279 electronic color code originally known as the RETMA color code; 300–399. EIA/ECA-310 Cabinets, Racks, Panels, and Associated Equipment, maintained by the ECIA (includes 19-inch racks, rack units)
A common application of the 25-pair color code is the cabling for the Registered Jack interface RJ21, which uses a female 50-pin miniature ribbon connector, as shown in the following table. The geometry of the pins of the receptacle (right hand image) corresponds to the pin numbers of the table.
The Joint Electronics Type Designation System (JETDS), which was previously known as the Joint Army-Navy Nomenclature System (AN System. JAN) and the Joint Communications-Electronics Nomenclature System , is a method developed by the U.S. War Department during World War II for assigning an unclassified designator to electronic equipment.
25-pair color code chart used in certain kinds of wiring. A color code is a system for encoding and representing non-color information with colors to facilitate communication. This information tends to be categorical (representing unordered/qualitative categories) though may also be sequential (representing an ordered/quantitative variable).
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with ...
Gallery 3’s CMYK displays can spit out 50,000 colors at 300 DPI — way, way up from Kaleido’s 4,000 colors, the company said. A prototype with E Ink’s Gallery 3 display tech. Image Credits ...