Search results
Results from the Tech24 Deals Content Network
Examples of such systems include modern cell phones, with GND and voltages such as 1.2 V, 1.8 V, 2.4 V, 3.3 V, and PCs, with GND and voltages such as −5 V, 3.3 V, 5 V, 12 V. Power-sensitive designs often have multiple power rails at a given voltage, using them to conserve energy by switching off supplies to components that are not in active use.
Three-phase transformer with four-wire output for 208Y/120 volt service: one wire for neutral, others for A, B and C phases. Three-phase electric power (abbreviated 3ϕ [1]) is a common type of alternating current (AC) used in electricity generation, transmission, and distribution. [2]
Fluorescent lamps typically require a two-pin, unthreaded socket. Not all lamps require a socket; for example, some miniature lamps have wire leads suitable for direct connection to screw terminals or other wires, and some reflector lamps provide screw terminals for electrical connections.
Pin 14: VSync: Vertical sync: Pin 15: ID3/SCL: I²C clock since DDC2, formerly monitor id. bit 3: The image and table detail the 15-pin VESA DDC2/E-DDC connector; the diagram's pin numbering is that of a female connector functioning as the graphics adapter output. In the male connector, this pin numbering corresponds with the cable's wire-and ...
National Electrical Code has been adopted for electrical wiring in the United States and for Mexico, Costa Rica, Venezuela and Colombia; IEC 60364 is used as a basis for electrical codes in many European countries; Canadian Electrical Code published by the CSA is used in Canada (see Electrical wiring in North America).
Round 7-pin trailer connector Type 1, Australian Standard 2513. In this pinout for an ISO 1724 connector, the position light pin is used for electric brakes (Pin 5, 58R), which means that if you connect a trailer with electric brakes to a towing vehicle wired according to ISO 1724 and turn on the position lights the trailer will be braking.
Two ribbon cables: the grey cable is stripped, and the rainbow cable has an IDC connector Connector blades IDC D-sub connectors DE-9 (male) and DA-15 (female) Connector blades cut insulation into the ribbon cable Australian (dual) power outlet, utilizing insulation displacement to connect mains voltage (230 V) supply conductors
Jumper pins (points to be connected by the jumper) are arranged in groups called jumper blocks, each group having at least one pair of contact points.An appropriately sized conductive sleeve called a jumper, or more technically, a shunt jumper, is slipped over the pins to complete the circuit.