Search results
Results from the Tech24 Deals Content Network
A 2.26 kΩ, 1%-precision resistor with 5 color bands (), from top, 2-2-6-1-1; the last two brown bands indicate the multiplier (×10) and the tolerance (1%).. An electronic color code or electronic colour code (see spelling differences) is used to indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others.
The first letter of the color code is matched by order of increasing magnitude. The electronic color codes, in order, are: 0 = Black; 1 = Brown; 2 = Red; 3 = Orange; 4 = Yellow; 5 = Green; 6 = Blue; 7 = Violet; 8 = Gray; 9 = White; Easy to remember. A mnemonic which includes color name(s) generally reduces the chances of confusing black and brown.
Ring color Significant figures Multiplier Tolerance Temperature coefficient Name Code RAL Percent [%] Letter [ppm/K] Letter; None – – – – ±20: M
25-pair color code chart used in certain kinds of wiring. A color code is a system for encoding and representing non-color information with colors to facilitate communication. This information tends to be categorical (representing unordered/qualitative categories) though may also be sequential (representing an ordered/quantitative variable).
84000347 [1] Significant dates. Added to NRHP. November 8, 1984. Designated CL. September 28, 1977. Old Town is a neighborhood and historic district in Near North Side and Lincoln Park, Chicago, Illinois, [2] [3] home to many of Chicago's older, Victorian-era buildings, including St. Michael's Church, one of seven buildings to survive the Great ...
A common application of the 25-pair color code is the cabling for the Registered Jack interface RJ21, which uses a female 50-pin miniature ribbon connector, as shown in the following table. The geometry of the pins of the receptacle (right hand image) corresponds to the pin numbers of the table.
Two decades of E12 values, which would give resistor values of 1 Ω to 82 Ω. The E series is a system of preferred numbers (also called preferred values) derived for use in electronic components. It consists of the E3, E6, E12, E24, E48, E96 and E192 series, [1] where the number after the 'E' designates the quantity of logarithmic value "steps ...
SMPTE ECR 1-1978 (SDTV) In a SMPTE color bar image, the top two-thirds of the television picture contain seven vertical bars of 75% intensity. In order from left to right, the colors are white or gray, yellow, cyan, green, magenta, red, and blue. [18] The choice of white or gray depends on whether that bar's luminance is 100% or not.