Search results
Results from the Tech24 Deals Content Network
Modern surface-mount electronic components on a printed circuit board, with a large integrated circuit at the top. Electronics is a scientific and engineering discipline that studies and applies the principles of physics to design, create, and operate devices that manipulate electrons and other electrically charged particles.
The load line diagram at right is for a resistive load in a common emitter circuit. The load line shows how the collector load resistor (R L ) constrains the circuit voltage and current. The diagram also plots the transistor's collector current I C versus collector voltage V CE for different values of base current I base .
Green electroluminescence from a point contact on a crystal of SiC recreates Round's original experiment from 1907. Close-up of a 1 watt red power led. Electroluminescence as a phenomenon was discovered in 1907 by the English experimenter H. J. Round of Marconi Labs, using a crystal of silicon carbide and a cat's-whisker detector.
Manufacturer's life-expectancy charts relate current, severity, and number of transients to make failure predictions based on the total energy dissipated over the life of the part. In consumer electronics, particularly surge protectors , the MOV varistor size employed is small enough that eventually failure is expected. [ 15 ]
The other nine units in ENIAC were the initiating unit (started and stopped the machine), the cycling unit (used for synchronizing the other units), the master programmer (controlled loop sequencing), the reader (controlled an IBM punch-card reader), the printer (controlled an IBM card punch), the constant transmitter, and three function tables.
Digital electronics is a field of electronics involving the study of digital signals and the engineering of devices that use or produce them. This is in contrast to analog electronics which work primarily with analog signals. Despite the name, digital electronics designs includes important analog design considerations.
Some disadvantages of pull-up resistors are the extra power consumed when current is drawn through the resistor and the reduced speed of a pull-up compared to an active current source. Certain logic families are susceptible to power supply transients introduced into logic inputs through pull-up resistors, which may force the use of a separate ...
Three-phase transformer with four-wire output for 208Y/120 volt service: one wire for neutral, others for A, B and C phases. Three-phase electric power (abbreviated 3ϕ [1]) is a common type of alternating current (AC) used in electricity generation, transmission, and distribution. [2]