Search results
Results from the Tech24 Deals Content Network
Different types of noise are generated by different devices and different processes. Thermal noise is unavoidable at non-zero temperature (see fluctuation-dissipation theorem), while other types depend mostly on device type (such as shot noise, [1] [3] which needs a steep potential barrier) or manufacturing quality and semiconductor defects, such as conductance fluctuations, including 1/f noise.
In response to this problem, Robert F. Gabriel, a Systems Engineer at Sperry Univac devised a large number of possible symbols that could be affixed to parts, packaging, and PCBs to alert the user that the part is ESD-sensitive. Gabriel developed a proposal for an ESD warning symbol and circulated it to numerous electronics standards groups. C.
Unlike board-level circuit design which permits the designer to select devices that have each been tested and binned according to value, the device values on an IC can vary widely which are uncontrollable by the designer. For example, some IC resistors can vary ±20% and β of an integrated BJT can vary from 20 to 100. In the latest CMOS ...
Three photoresistors with scale in mm Large CdS photocell from a street light. A photoresistor is less light-sensitive than a photodiode or a phototransistor.The latter two components are true semiconductor devices, while a photoresistor is a passive component that does not have a PN-junction.
A line-level attenuator has lower power handling, such as a 1/2-watt potentiometer or voltage divider and controls preamp level signals, whereas a power attenuator has higher power handling capability, such as 10 watts or more, and is used between the power amplifier and the speaker. Power attenuator (guitar) Guitar amplifier
In electronics, electric power and telecommunication, coupling is the transfer of electrical energy from one circuit to another, or between parts of a circuit. Coupling can be deliberate as part of the function of the circuit, or it may be undesirable, for instance due to coupling to stray fields.
A 1953 paper "Coding by Feedback Methods" [1] describes "decoding networks" that convert numbers (in any base) represented by voltage sources or current sources connected to resistor networks in a "shunt resistor decoding network" (which in base 2 corresponds to the binary-weighted configuration) or in a "ladder resistor decoding network" (which in base 2 corresponds to R–2R configuration ...
To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...