Search results
Results from the Tech24 Deals Content Network
Silver. ±10%. None. ±20%. The first letter of the color code is matched by order of increasing magnitude. The electronic color codes, in order, are: 0 = B lack. 1 = B rown. 2 = R ed.
A 2.26 kΩ, 1%-precision resistor with 5 color bands (), from top, 2-2-6-1-1; the last two brown bands indicate the multiplier (×10) and the tolerance (1%).. An electronic color code or electronic colour code (see spelling differences) is used to indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others.
A common application of the 25-pair color code is the cabling for the Registered Jack interface RJ21, which uses a female 50-pin miniature ribbon connector, as shown in the following table. The geometry of the pins of the receptacle (right hand image) corresponds to the pin numbers of the table.
Indicator (distance amplifying instrument) A precision dial indicator, with a sensitivity of 0.01 mm and range of 10 mm. In various contexts of science, technology, and manufacturing (such as machining, fabricating, and additive manufacturing ), an indicator is any of various instruments used to accurately measure small distances and angles ...
An inclinometer or clinometer is an instrument used for measuring angles of slope, elevation, or depression of an object with respect to gravity 's direction. It is also known as a tilt indicator, tilt sensor, tilt meter, slope alert, slope gauge, gradient meter, gradiometer, level gauge, level meter, declinometer, and pitch & roll indicator.
Milling is the process of machining using rotary cutters to remove material [ 1] by advancing a cutter into a workpiece. This may be done by varying directions [ 2] on one or several axes, cutter head speed, and pressure. [ 3] Milling covers a wide variety of different operations and machines, on scales from small individual parts to large ...
Lathe center. Dead center (the conical piece) mounted in the spindle of a lathe and being used to support a workpiece being driven by a carrier setup. A lathe center, often shortened to center, is a tool that has been ground to a point to accurately position a workpiece on an axis. They usually have an included angle of 60°, but in heavy ...
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with ...