Search results
Results from the Tech24 Deals Content Network
Silver. ±10%. None. ±20%. The first letter of the color code is matched by order of increasing magnitude. The electronic color codes, in order, are: 0 = B lack. 1 = B rown. 2 = R ed.
A 2.26 kΩ, 1%-precision resistor with 5 color bands (), from top, 2-2-6-1-1; the last two brown bands indicate the multiplier (×10) and the tolerance (1%).. An electronic color code or electronic colour code (see spelling differences) is used to indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others.
List of resistors. Axial -lead resistors on tape. The component is cut from the tape during assembly and the part is inserted into the board. Size comparison of axial-lead resistors. A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element.
Electronic symbol. An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may vary from country to country ...
Resistor. A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages, bias active elements, and terminate transmission lines, among other uses.
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with ...
Ring color Significant figures Multiplier Tolerance Temperature coefficient Name Code RAL Percent [%] Letter [ppm/K] Letter; None – – – – ±20: M
For brevity, the notation omits to always specify the unit (ohm or farad) explicitly and instead relies on implicit knowledge raised from the usage of specific letters either only for resistors or for capacitors, [nb 1] the case used (uppercase letters are typically used for resistors, lowercase letters for capacitors), [nb 2] a part's appearance, and the context.