Search results
Results from the Tech24 Deals Content Network
OBD-II PIDs. OBD-II PIDs ( On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
On-board diagnostics. Various views of a "MaxScan OE509" – a fairly typical onboard diagnostics (OBD) scanner, 2015. On-board diagnostics ( OBD) is a term referring to a vehicle's self-diagnostic and reporting capability. In the United States, this capability is a requirement to comply with federal emissions standards to detect failures that ...
Unified Diagnostic Services ( UDS) is a diagnostic communication protocol used in electronic control units (ECUs) within automotive electronics, which is specified in the ISO 14229-1. [ 1] It is derived from ISO 14230-3 ( KWP2000) and the now obsolete ISO 15765 -3 (Diagnostic Communication over Controller Area Network (DoCAN) [ 2] ).
Two sets, or tiers, of emission standards for light-duty vehicles in the United States were defined as a result of the Clean Air Act Amendments of 1990. The Tier I standard was adopted in 1991 and was phased in from 1994 to 1997. Tier II standards were phased in from 2004 to 2009. Within the Tier II ranking, there is a subranking ranging from ...
Oxygen sensor. An oxygen sensor (or lambda sensor, where lambda refers to air–fuel equivalence ratio, usually denoted by λ) or probe or sond, is an electronic device that measures the proportion of oxygen (O 2) in the gas or liquid being analyzed. It was developed by Robert Bosch GmbH during the late 1960s under the supervision of Günter ...
Engine controls demand one of the highest real-time deadlines, as the engine itself is a very fast and complex part of the automobile. Of all the electronics in any car, the computing power of the engine control unit is the highest, typically a 32-bit processor. [citation needed] A modern car may have up to 100 ECU's and a commercial vehicle up ...
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
A check engine light or malfunction indicator lamp ( MIL ), is a tell-tale that a computerized engine-management system used to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.). Found on the instrument panel of most ...