Search results
Results from the Tech24 Deals Content Network
List of electronic color code mnemonics Mnemonics are used to help memorize the electronic color codes for resistors. Mnemonics describing specific and relatable scenarios are more memorable than abstract phrases.
An electronic color code or electronic colour code (see spelling differences) is used to indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others.
This is a list of notable RGB hardware color palettes used on 16-bit computers, which were primarily manufactured from 1985 to 1995. Due to mixed-bit architectures, the n -bit distinction is not always a strict categorization.
This is a full list of color palettes for notable video game console hardware. For each unique palette, an image color test chart and sample image (original True color version follows) rendered with that palette (without dithering unless otherwise noted) are given. The test chart shows the full 8-bit, 256 levels of the red, green and blue ( RGB ...
The E series is a system of preferred numbers (also called preferred values) derived for use in electronic components. It consists of the E3, E6, E12, E24, E48, E96 and E192 series, [1] where the number after the 'E' designates the quantity of logarithmic value "steps" per decade. Although it is theoretically possible to produce components of any value, in practice the need for inventory ...
25-pair telco cable pinout A common application of the 25-pair color code is the cabling for the Registered Jack interface RJ21, which uses a female 50-pin miniature ribbon connector, as shown in the following table. The geometry of the pins of the receptacle (right hand image) corresponds to the pin numbers of the table.
^ For illustration only. IEC 60062:2016 and IEC 60757:1982 do not specify or intend to specify color boundaries and properties, and colors shown here as example are applied for the purpose of consistent illustration only. ^ a b Before yellow and grey colored rings were assigned to tolerance values of ±0.02% and ±0.01% with IEC 60062:2016, some manufacturers used yellow and grey as substitute ...
25-pair color code chart used in certain kinds of wiring. A color code is a system for encoding and representing non-color information with colors to facilitate communication. This information tends to be categorical (representing unordered/qualitative categories) though may also be sequential (representing an ordered/quantitative variable).