Ads
related to: electronic color code resistors calculator converter 2 to 1
Search results
Results from the Tech24 Deals Content Network
A 2.26 kΩ, 1%-precision resistor with 5 color bands (), from top, 2-2-6-1-1; the last two brown bands indicate the multiplier (×10) and the tolerance (1%).. An electronic color code or electronic colour code (see spelling differences) is used to indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others.
A mnemonic which includes color name(s) generally reduces the chances of confusing black and brown. Some mnemonics that are easy to remember: Big Boys Race Our Young Girls But Violet Generally Wins. Better Be Right Or Your Great Big Venture Goes West. [1] Beetle Bailey Runs Over Your General Before Very Good Witnesses.
Resistor ladder. A resistor ladder is an electrical circuit made from repeating units of resistors, in specific configurations. An R–2R ladder configuration is a simple and inexpensive way to perform digital-to-analog conversion (DAC), using repetitive arrangements of precise resistor networks in a ladder -like configuration.
For example, a 10 ohm resistor connected in parallel with a 5 ohm resistor and a 15 ohm resistor produces 1 / 1/10 + 1/5 + 1/15 ohms of resistance, or 30 / 11 = 2.727 ohms. A resistor network that is a combination of parallel and series connections can be broken up into smaller parts that are either one or the other.
Two decades of E12 values, which would give resistor values of 1 Ω to 82 Ω. The E series is a system of preferred numbers (also called preferred values) derived for use in electronic components. It consists of the E3, E6, E12, E24, E48, E96 and E192 series, [ 1] where the number after the 'E' designates the quantity of logarithmic value ...
In power supply design, a bridge circuit or bridge rectifier is an arrangement of diodes or similar devices used to rectify an electric current, i.e. to convert it from an unknown or alternating polarity to a direct current of known polarity. In some motor controllers, an H-bridge is used to control the direction the motor turns.
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with ...
Ring color Significant figures Multiplier Tolerance Temperature coefficient Name Code RAL Percent [%] Letter [ppm/K] Letter; None – – – – ±20: M
Ads
related to: electronic color code resistors calculator converter 2 to 1