Search results
Results from the Tech24 Deals Content Network
The decibel (symbol: dB) is a relative unit of measurement equal to one tenth of a bel ( B ). It expresses the ratio of two values of a power or root-power quantity on a logarithmic scale. Two signals whose levels differ by one decibel have a power ratio of 10 1/10 (approximately 1.26) or root-power ratio of 10 1/20 (approximately 1.12 ).
The plots at the bottom show the signal intensity in the indicated row of the image (red: original signal, blue: with noise). Signal-to-noise ratio ( SNR or S/N) is a measure used in science and engineering that compares the level of a desired signal to the level of background noise. SNR is defined as the ratio of signal power to noise power ...
Dynamic range (abbreviated DR, DNR, [1] or DYR [2]) is the ratio between the largest and smallest values that a certain quantity can assume. It is often used in the context of signals, like sound and light. It is measured either as a ratio or as a base-10 ( decibel) or base-2 (doublings, bits or stops) logarithmic value of the ratio between the ...
Peak signal-to-noise ratio ( PSNR) is an engineering term for the ratio between the maximum possible power of a signal and the power of corrupting noise that affects the fidelity of its representation. Because many signals have a very wide dynamic range, PSNR is usually expressed as a logarithmic quantity using the decibel scale.
Sound intensity, also known as acoustic intensity, is defined as the power carried by sound waves per unit area in a direction perpendicular to that area. The SI unit of intensity, which includes sound intensity, is the watt per square meter (W/m 2 ). One application is the noise measurement of sound intensity in the air at a listener's ...
Infrasound, sometimes referred to as low frequency sound, describes sound waves with a frequency below the lower limit of human audibility (generally 20 Hz, as defined by the ANSI/ASA S1.1-2013 standard). [1] Hearing becomes gradually less sensitive as frequency decreases, so for humans to perceive infrasound, the sound pressure must be ...
A gain greater than one (greater than zero dB), that is, amplification, is the defining property of an active component or circuit, while a passive circuit will have a gain of less than one. [4] The term gain alone is ambiguous, and can refer to the ratio of output to input voltage ( voltage gain ), current ( current gain ) or electric power ...
Spectral density. The spectral density of a fluorescent light as a function of optical wavelength shows peaks at atomic transitions, indicated by the numbered arrows. The voice waveform over time (left) has a broad audio power spectrum (right). In signal processing, the power spectrum of a continuous time signal describes the distribution of ...