Search results
Results from the Tech24 Deals Content Network
OBD-II PIDs. OBD-II PIDs ( On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
On-board diagnostics. Various views of a "MaxScan OE509" – a fairly typical onboard diagnostics (OBD) scanner, 2015. On-board diagnostics ( OBD) is a term referring to a vehicle's self-diagnostic and reporting capability. In the United States, this capability is a requirement to comply with federal emissions standards to detect failures that ...
A check engine light or malfunction indicator lamp ( MIL ), is a tell-tale that a computerized engine-management system used to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.). Found on the instrument panel of most ...
Unified Diagnostic Services ( UDS) is a diagnostic communication protocol used in electronic control units (ECUs) within automotive electronics, which is specified in the ISO 14229-1. [ 1] It is derived from ISO 14230-3 ( KWP2000) and the now obsolete ISO 15765 -3 (Diagnostic Communication over Controller Area Network (DoCAN) [ 2] ).
ELM327. The ELM327 is a programmed microcontroller produced for translating the on-board diagnostics (OBD) interface found in most modern cars. The ELM327 command protocol is one of the most popular PC-to-OBD interface standards and is also implemented by other vendors. The original ELM327 was implemented on the PIC18F2480 microcontroller from ...
Failure mode and effects analysis. Failure mode and effects analysis ( FMEA; often written with "failure modes" in plural) is the process of reviewing as many components, assemblies, and subsystems as possible to identify potential failure modes in a system and their causes and effects. For each component, the failure modes and their resulting ...
A low code-rate close to zero implies a strong code that uses many redundant bits to achieve a good performance, while a large code-rate close to 1 implies a weak code. The redundant bits that protect the information have to be transferred using the same communication resources that they are trying to protect.
Crankshaft position sensor. A crank sensor (CKP) [ 1][ 2][ 3] is an electronic device used in an internal combustion engine, both petrol and diesel, to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control the fuel injection or the ignition system timing and other engine ...