Search results
Results from the Tech24 Deals Content Network
The mixture of steam and water is led by the upper steam lines, one for each pressure channel, from the reactor top to the steam separators, pairs of thick horizontal drums located in side compartments above the reactor top; each has 2.8 m (9 ft 2 in) diameter, 31 m (101 ft 8 in) length, wall thickness of 10 cm (3.9 in), and weighs 240 t (260 ...
The ASME Boiler & Pressure Vessel Code (BPVC) is an American Society of Mechanical Engineers (ASME) standard that regulates the design and construction of boilers and pressure vessels. [1] The document is written and maintained by volunteers chosen for their technical expertise . [2] The ASME works as an accreditation body and entitles ...
A WWER-1000 (or VVER-1000 as a direct transliteration of Russian ВВЭР-1000), a 1000 MWe Russian nuclear power reactor of PWR type. 1: control rod drives. 2: reactor cover [ 10] or vessel head [ 11] 3: Reactor pressure vessel. 4: inlet and outlet nozzles.
A simplified diagram of a two-phase alternator [1] Two-phase electrical power was an early 20th-century polyphase alternating current electric power distribution system. Two circuits were used, with voltage phases differing by one-quarter of a cycle, 90°. Usually circuits used four wires, two for each phase.
Notably, steam is not created in the core (as is present in boiling water reactors), and no large, expensive steel pressure vessel (as required for pressurized water reactors). Since it can operate at high temperatures, the conversion of the heat to electricity can use an efficient, lightweight Brayton cycle gas turbine.
A welded steel pressure vessel constructed as a horizontal cylinder with domed ends. An access cover can be seen at one end, and a drain valve at the bottom centre. A pressure vessel is a container designed to hold gases or liquids at a pressure substantially different from the ambient pressure . Construction methods and materials may be chosen ...
EN 13445-10. EN 13445 - Unfired Pressure Vessels is a standard that provides rules for the design, fabrication, and inspection of pressure vessels. EN 13445 consists of 8 parts: EN 13445-1 : Unfired pressure vessels - Part 1: General. EN 13445-2 : Unfired pressure vessels - Part 2: Materials. EN 13445-3 : Unfired pressure vessels - Part 3: Design.
A shell-and-tube heat exchanger is a class of heat exchanger designs. [ 1][ 2] It is the most common type of heat exchanger in oil refineries and other large chemical processes, and is suited for higher-pressure applications. As its name implies, this type of heat exchanger consists of a shell (a large pressure vessel) with a bundle of tubes ...