Search results
Results from the Tech24 Deals Content Network
Overhead power transmission lines are classified in the electrical power industry by the range of voltages: Low voltage (LV) – less than 1000 volts, used for connection between a residential or small commercial customer and the utility.
The electrical resistance of an object is a measure of its opposition to the flow of electric current. Its reciprocal quantity is electrical conductance, measuring the ease with which an electric current passes. Electrical resistance shares some conceptual parallels with mechanical friction.
An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may vary from country to country, or engineering ...
A General Electric NE-34 glow lamp, manufactured circa 1930. Neon was discovered in 1898 by William Ramsay and Morris Travers.The characteristic, brilliant red color that is emitted by gaseous neon when excited electrically was noted immediately; Travers later wrote, "the blaze of crimson light from the tube told its own story and was a sight to dwell upon and never forget."
Electronic color code – color-code used to indicate the values of axial electronic components, such as resistors, capacitors, inductors, diodes (also see IEC 60062). Geometric progression; Preferred number; Renard series – used for current rating of electric fuses
Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...
A time-domain reflectometer; an instrument used to locate the position of faults on lines from the time taken for a reflected wave to return from the discontinuity.. A signal travelling along an electrical transmission line will be partly, or wholly, reflected back in the opposite direction when the travelling signal encounters a discontinuity in the characteristic impedance of the line, or if ...
Surge Protection Device (SPD) for installation in a low-voltage distribution board. A surge protector (or spike suppressor, surge suppressor, surge diverter, [1] surge protection device (SPD) or transient voltage surge suppressor (TVSS) is an appliance or device intended to protect electrical devices in alternating current (AC) circuits from voltage spikes with very short duration measured in ...