Search results
Results from the Tech24 Deals Content Network
The Combined Charging System ( CCS) is a standard for charging electric vehicles. It can use Combo 1 ( CCS1) or Combo 2 ( CCS2) connectors to provide power at up to 350 kilowatts (kW) (max 500 A). [ 1] These two connectors are extensions of the IEC 62196 Type 1 and Type 2 connectors, with two additional direct current (DC) contacts to allow ...
A residual-current device (RCD), residual-current circuit breaker (RCCB) or ground fault circuit interrupter (GFCI) [a] is an electrical safety device that interrupts an electrical circuit when the current passing through a conductor is not equal and opposite in both directions, therefore indicating leakage current to ground or current flowing to another powered conductor.
The CC-Link Partner Association (CLPA) offers a family of open-architecture networks. These originated with the CC-Link (Control & Communication) fieldbus in 1996, [1] developed by Mitsubishi Electric Corporation. In 2000, [1] this was released as an “Open” network so that independent automation equipment manufacturers could incorporate ...
Straighten each of the wires and pull them together so they're flat and in the right order. Cut the wires across the tips so that they are flat across the end. Use a smaller wire cutter so that ...
To complete this project, you need: A suitable GPS receiver. 26 gauge wire (0.4mm thick) 100pF or 47pf ceramic capacitor. Active external GPS antenna. BNC panel mount connector (may vary, get one ...
SAE J1772, also known as a J plug or Type 1 connector after its international standard, IEC 62196 Type 1, is a North American standard for electrical connectors for electric vehicles maintained by SAE International under the formal title "SAE Surface Vehicle Recommended Practice J1772, SAE Electric Vehicle Conductive Charge Coupler". [ 1]
Cable. Coaxial. Passband. Typically 0–4 GHz. The BNC connector (initialism of "Bayonet Neill–Concelman") is a miniature quick connect/disconnect radio frequency connector used for coaxial cable. It is designed to maintain the same characteristic impedance of the cable, with 50 ohm and 75 ohm types being made. It is usually applied for video ...
Exploiting these flaws is complex but programming errors in Wi-Fi products are easier to exploit. Despite improvements in Wi-Fi security, these findings highlight the need for continuous security analysis and updates. In response, security patches were developed, and users are advised to use HTTPS and install available updates for protection. [62]