Search results
Results from the Tech24 Deals Content Network
The Charrière is measured by the ''outer'' diameter, and is defined as 1 Fr = 1/3 mm, and thus 1 mm = 3 Fr; therefore the diameter of a round catheter in millimetres can be determined by dividing the French size by 3. [2] The French units roughly correspond to the outer circumference of the catheter (see table below).
At the "744 Conference" the caliber choice was narrowed down to either 5.8 or 6 mm (0.23 or 0.24 in). Seven different case designs were presented, which required overall cartridge lengths between 56 and 59.5 mm (2.20–2.34 in). The actual development began in 1978.
The microwave is between 1 meter to 1 millimeter. The millimetre ( international spelling; SI unit symbol mm) or millimeter ( American spelling) is a unit of length in the International System of Units (SI), equal to one thousandth of a metre, which is the SI base unit of length. Therefore, there are one thousand millimetres in a metre.
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
So a 1 / 2 in (12.7 mm) diameter drill will be able to drill a hole 4 + 1 / 2 in (114.3 mm) deep, since it is 9 times the diameter in length. A 1 / 8 in (3.175 mm) diameter drill can drill a hole 1 + 5 / 8 in (41.275 mm) deep, since it is 13 times the diameter in flute length.
Used for 12 mm, and 12.5 mm figure scale miniature wargaming. 1:128: 3 ⁄ 32 in: 2.381 mm A few rockets and some fit-in-the-box aircraft are made to this size. 1:120: 0.1 in: 2.54 mm: Model railways (TT) Derived from the scale of 1 inch equals 10 feet.TT model railroad scale. Used in AD&D Battlesystem Skirmishes rules. Works with 15 mm ...
To help compare different orders of magnitude this page lists lengths between 10 −3 and 10 −2 m (1 mm and 1 cm). 1.0 mm — 1 / 1000 of a metre; 1.0 mm — 0.039 37 inches or 5 ⁄ 127 (exactly) 1.0 mm — side of square of area 1 mm 2; 1.0 mm — diameter of a pinhead; 1.5 mm — length of average flea
The newer 2 1 ⁄ 2 inch and 1.8 inch drive bays are specified in metric and use metric mounting screws. Newer SSDs in the M.2 form factor are measured in millimeters (e.g., "M.2 2280" is 22 mm wide by 80 mm long).