Search results
Results from the Tech24 Deals Content Network
The first letter of the color code is matched by order of increasing magnitude. The electronic color codes, in order, are: 0 = Black; 1 = Brown; 2 = Red; 3 = Orange; 4 = Yellow; 5 = Green; 6 = Blue; 7 = Violet; 8 = Gray; 9 = White; Easy to remember. A mnemonic which includes color name(s) generally reduces the chances of confusing black and brown.
A 2.26 kΩ, 1%-precision resistor with 5 color bands (), from top, 2-2-6-1-1; the last two brown bands indicate the multiplier (×10) and the tolerance (1%).. An electronic color code or electronic colour code (see spelling differences) is used to indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others.
Two electrodes. Concrete electrical resistance can be measured by applying a current using two electrodes attached to the ends of a uniform cross-section specimen. Electrical resistivity is obtained from the equation: [1] R is the electrical resistance of the specimen, the ratio of voltage to current (measured in ohms, Ω) ℓ {\displaystyle \ell }
As already mentioned, when two colors are mixed, the resulting color x mix, y mix will lie on the straight line segment that connects these colors on the CIE xy chromaticity diagram. To calculate the mixing ratio of the component colors x 1 ,y 1 and x 2 ,y 2 that results in a certain x mix ,y mix on this line segment, one can use the formula
A common application of the 25-pair color code is the cabling for the Registered Jack interface RJ21, which uses a female 50-pin miniature ribbon connector, as shown in the following table. The geometry of the pins of the receptacle (right hand image) corresponds to the pin numbers of the table.
The test hammer hits the concrete at a defined energy. Its rebound is dependent on the hardness of the concrete and is measured by the test equipment. By reference to a conversion chart, the rebound value can be used to determine the concrete's compressive strength. When conducting the test, the hammer should be held at right angles to the ...
Tiltmeters may be purely mechanical or incorporate vibrating-wire or electrolytic sensors for electronic measurement. A sensitive instrument can detect changes of as little as one arc second . Tiltmeters have a long history, somewhat parallel to the history of the seismometer. The very first tiltmeter was a long-length stationary pendulum.
The E series is a system of preferred numbers (also called preferred values) derived for use in electronic components. It consists of the E3, E6, E12, E24, E48, E96 and E192 series, [1] where the number after the 'E' designates the quantity of logarithmic value "steps" per decade. Although it is theoretically possible to produce components of ...