Search results
Results from the Tech24 Deals Content Network
IP65 touchscreen display IP65 LED lamp. The IP code or ingress protection code indicates how well a device is protected against water and dust. It is defined by the International Electrotechnical Commission (IEC) under the international standard IEC 60529 [1] which classifies and provides a guideline to the degree of protection provided by mechanical casings and electrical enclosures against ...
Electronic components have a wide range of failure modes. These can be classified in various ways, such as by time or cause. Failures can be caused by excess temperature, excess current or voltage, ionizing radiation, mechanical shock, stress or impact, and many other causes. In semiconductor devices, problems in the device package may cause ...
An axial-lead through-hole zero-ohm resistor is generally marked with a single black band, the symbol for "0" in the resistor color code. Surface-mount zero-ohm resistors are usually marked with a single or multiple "0" (if size allows marking), where the number of digits can indicate the tolerance or maximum resistance rating, as is the case ...
Simple LED (Light Emitting Diode) circuit diagram. In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED.
A Molex connector is a two-piece pin-and-socket interconnection which became an early electronic standard. Developed by Molex Connector Company in the late 1950s, the design features cylindrical spring-metal pins that fit into cylindrical spring-metal sockets, both held in a rectangular matrix in a nylon shell.
Three photoresistors with scale in mm Large CdS photocell from a street light. A photoresistor is less light-sensitive than a photodiode or a phototransistor.The latter two components are true semiconductor devices, while a photoresistor is a passive component that does not have a PN-junction.
Different keying for each colour in the SB50 series. Note that black and grey are keyed the same making them interchangeable. For the larger multipole design, which is available in up to 700 A sizes, each color is physically keyed so as to mate only with a like colored connector, and Anderson published a list of recommended voltage for each color:
RS-485, also known as TIA-485(-A) or EIA-485, is a standard, originally introduced in 1983, defining the electrical characteristics of drivers and receivers for use in serial communications systems.