Tech24 Deals Web Search

Search results

1. Results from the Tech24 Deals Content Network

2. OG-107 - Wikipedia

   en.wikipedia.org/wiki/OG-107

   OG-107. A U.S. Army soldier wearing an OG-507 uniform in 1977. The OG-107 was the basic work and combat utility uniform (fatigues) of all branches of the United States Armed Forces from 1952 until its discontinuation in 1989. The designation came from the U.S. Army 's coloring code " Olive Green 107", which was the shade of dark green used on ...

3. Joint European standard for size labelling of clothes

   en.wikipedia.org/wiki/Joint_European_standard...

   European Standard (EN 13402-1) pictogram example for a men's jacket, with chest as primary measurement, and height and waist as secondary measurements. The first part [ 2 ] of the standard defines the list of body dimensions to be used for designating clothing sizes, together with an anatomical explanations and measurement guidelines.

4. Guccio Gucci - Wikipedia

   en.wikipedia.org/wiki/Guccio_Gucci

   Guccio Gucci was born in Florence, Tuscany on 26 March 1881. [ 1] He was the son of Tuscan parents, Gabriello Gucci, a leather craftsman from San Miniato, and Elena Santini, from Lastra a Signa. [ 2][ 3] As a teenager, in 1899, Guccio Gucci worked at the Savoy Hotel in London. [ 4][ 5] Little is known about his early life circumstances and what ...

5. Belt (clothing) - Wikipedia

   en.wikipedia.org/wiki/Belt_(clothing)

   A belt is a flexible band or strap, typically made of leather, plastic, or heavy cloth, worn around the natural waist or near it (as far down as the hips ). The ends of a belt are free; and a buckle forms the belt into a loop by securing one end to another part of the belt, at or near the other end. Often, the resulting loop is smaller than the ...

6. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

7. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.