Search results
Results from the Tech24 Deals Content Network
A 2.26 kΩ, 1%-precision resistor with 5 color bands (), from top, 2-2-6-1-1; the last two brown bands indicate the multiplier (×10) and the tolerance (1%).. An electronic color code or electronic colour code (see spelling differences) is used to indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others.
Silver. ±10%. None. ±20%. The first letter of the color code is matched by order of increasing magnitude. The electronic color codes, in order, are: 0 = B lack. 1 = B rown. 2 = R ed.
IEC 60227 Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V. IEC 60228 Conductors of insulated cables. IEC 60229 Electric cables – Tests on extruded over-sheaths with a special protective function. IEC 60230 Impulse tests on cables and their accessories.
The time-to-digital converter measures the time between a start event and a stop event. There is also a digital-to-time converter or delay generator. The delay generator converts a number to a time delay. When the delay generator gets a start pulse at its input, then it outputs a stop pulse after the specified delay.
Calibration. In measurement technology and metrology, calibration is the comparison of measurement values delivered by a device under test with those of a calibration standard of known accuracy. Such a standard could be another measurement device of known accuracy, a device generating the quantity to be measured such as a voltage, a sound tone ...
The aim of color calibration is to measure and/or adjust the color response of a device (input or output) to a known state. [ 1] In International Color Consortium (ICC) terms, this is the basis for an additional color characterization of the device and later profiling. [ 2] In non-ICC workflows, calibration sometimes refers to establishing a ...
A common application of the 25-pair color code is the cabling for the Registered Jack interface RJ21, which uses a female 50-pin miniature ribbon connector, as shown in the following table. The geometry of the pins of the receptacle (right hand image) corresponds to the pin numbers of the table.
25-pair color code chart used in certain kinds of wiring. A color code is a system for encoding and representing non-color information with colors to facilitate communication. This information tends to be categorical (representing unordered/qualitative categories) though may also be sequential (representing an ordered/quantitative variable).