Tech24 Deals Web Search

  1. Ads

    related to: holes between 3 ring binder 3x5

Search results

  1. Results from the Tech24 Deals Content Network
  2. Ring binder - Wikipedia

    en.wikipedia.org/wiki/Ring_binder

    The distances between holes are 80 millimetres (3.1 in) (3 × 8). The most common type in Canada and the United States is a three-ring system for letter size pages ( 8 + 1 ⁄ 2 by 11 inches or 220 mm × 280 mm), whose size is similar to ISO 216-based A4 size.

  3. Wire binding - Wikipedia

    en.wikipedia.org/wiki/Wire_binding

    Wire binding. Wire binding is a popular commercial book binding method, and is known by various names, including double loop wire, double-o, ring wire, twin loop wire, wire comb, wire-o, wirebind and wiro. With this binding method, users insert their punched pages onto a C-shaped spine, and then use a wire closer to squeeze the spine until it ...

  4. Comb binding - Wikipedia

    en.wikipedia.org/wiki/Comb_binding

    2". 51 mm. 425. Comb binding (sometimes referred to as "cerlox" or "surelox" binding) is one of many ways to bind pages together into a book. This method uses round plastic spines with 19 rings (for US Letter size) or 21 rings (for A4 size) and a hole puncher that makes rectangular holes. Comb binding is sometimes referred to as plastic comb ...

  5. Loose leaf - Wikipedia

    en.wikipedia.org/wiki/Loose_leaf

    In North America, 3-hole binders for letter-size papers typically have a width of 1/2 inch, 1 inch, 1.5 inches, 2 inches, 3 inches or 4 inches; in ISO system, binders typically have a width of less than 3 cm. “Discbound” loose leaf systems, which uses separate “discs” to hold covers and pages. Staples and Office Depot sell discbound ...

  6. Hole punch - Wikipedia

    en.wikipedia.org/wiki/Hole_punch

    A hole punch, also known as hole puncher, or paper puncher, is an office tool that is used to create holes in sheets of paper, often for the purpose of collecting the sheets in a binder or folder (such collected sheets are called loose leaves ). A hole punch can also refer to similar tools for other materials, such as leather, cloth, or sheets ...

  7. Sand casting - Wikipedia

    en.wikipedia.org/wiki/Sand_casting

    Cross-sections as small as 0.090 in (2.3 mm) are possible. The surface finish is very good, usually between 150 and 125 rms. Other advantages include no moisture related defects, no cost for binders, excellent sand permeability, and no toxic fumes from burning the binders. Finally, the pattern does not wear out because the sand does not touch it.

  1. Ads

    related to: holes between 3 ring binder 3x5