Search results
Results from the Tech24 Deals Content Network
On-board diagnostics. Various views of a "MaxScan OE509" – a fairly typical onboard diagnostics (OBD) scanner, 2015. On-board diagnostics ( OBD) is a term referring to a vehicle's self-diagnostic and reporting capability. In the United States, this capability is a requirement to comply with federal emissions standards to detect failures that ...
A spline is a ridge or tooth [ 1][ 2][ 3] on a drive shaft that matches with a groove in a mating piece and transfers torque to it, maintaining the angular correspondence between them. For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear. Adjacent images in the section below ...
Strain wave gearing (also known as harmonic gearing) is a type of mechanical gear system that uses a flexible spline with external teeth, which is deformed by a rotating elliptical plug to engage with the internal gear teeth of an outer spline. The German company Harmonic Drive SE manufactured the first series-produced gears under the product ...
Getrag F23 transmission. The F23 is a five-speed manual transmission manufactured by Getrag in Italy. [citation needed] It is designed for transverse engine applications, primarily by General Motors. It can handle torque inputs of over 230 newton-metres (170 lbf⋅ft ). The F23 has one roll pin, two gearsets on each of three parallel shafts ...
A check engine light or malfunction indicator lamp ( MIL ), is a tell-tale that a computerized engine-management system used to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.). Found on the instrument panel of most ...
SAE J1587. Society of Automotive Engineers standard SAE J1587 is an automotive diagnostic protocol standard developed by the Society of Automotive Engineers (SAE) for heavy-duty and most medium-duty vehicles built after 1985. The J1587 protocol uses different diagnostic connectors. Up to 1995, individual OEMs used their own connectors.
The Ford 8.8 is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1983 Ford trucks. The axle was developed to replace the Ford 9-inch axle. This axle is still in production today for a variety of Ford vehicles.
And it said it had expanded its Shield Repair Network "by adding more than 10,000 preferred car repair shops, and added a concierge system to help customers quickly locate a repair facility ...