Search results
Results from the Tech24 Deals Content Network
The color combinations are applied to the insulation that covers each conductor. Typically, one color is a prominent background color of the insulation, and the other is a tracer, consisting of stripes, rings, or dots, applied over the background. The background color always matches the tracer color of its paired conductor, and vice versa.
The IP code or ingress protection code indicates how well a device is protected against water and dust. It is defined by the International Electrotechnical Commission (IEC) under the international standard IEC 60529 [ 1 ] which classifies and provides a guideline to the degree of protection provided by mechanical casings and electrical ...
Target rating points quantify the gross rated points achieved by an advertisement or campaign among targeted individuals within a larger population. [ 2 ] For example, if an advertisement appears more than once, the entire gross audience, the TRP figure is the sum of each individual GRP, multiplied by the estimated target audience in the gross ...
An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may vary from country to country, or engineering ...
An axial-lead through-hole zero-ohm resistor is generally marked with a single black band, the symbol for "0" in the resistor color code. Surface-mount zero-ohm resistors are usually marked with a single or multiple "0" (if size allows marking), where the number of digits can indicate the tolerance or maximum resistance rating, as is the case ...
One of the functions of many types of multimeters is the measurement of resistance in ohms.. The ohm is defined as an electrical resistance between two points of a conductor when a constant potential difference of one volt (V), applied to these points, produces in the conductor a current of one ampere (A), the conductor not being the seat of any electromotive force.
In some applications, the internal resistance of small batteries is sufficient to keep current within the LED rating. [citation needed] LEDs are sensitive to voltage. They must be supplied with a voltage above their threshold voltage and a current below their rating. Current and lifetime change greatly with a small change in applied voltage.
Surface-mount technology was developed in the 1960s. By 1986 surface mounted components accounted for 10% of the market at most, but was rapidly gaining popularity. [4] By the late 1990s, the great majority of high-tech electronic printed circuit assemblies were dominated by surface mount devices.